Detail Atlas · Drip Edge & Roof Edge
Gravel Stop
The FlashDraft section for this condition, in 3D and as a lettered section.
Show
Loading 3D view…
Legs
| Leg | Length |
|---|---|
| A | Drawn to proportion - set it in FlashDraft |
| B | Drawn to proportion - set it in FlashDraft |
| C | Drawn to proportion - set it in FlashDraft |
| D | Drawn to proportion - set it in FlashDraft |
| E | Drawn to proportion - set it in FlashDraft |
Related calculators
- Flashing Profile & Bend Development - Legs, bends and hems to a blank width, bend schedule, weight and an AFS fabrication check.
- Roof Edge, Coping & Fascia - Edge runs, corners and terminations to pieces, joints, end caps and cleat length.
- Thermal Movement & Compatibility - Expansion and contraction of a run between metal temperature extremes, and dissimilar-metal screening.
- Wind Uplift & Edge Screening - ASCE 7-16 edge pressures for comparison with ES-1 tested capacity. Preliminary.
Drexel ES-1 systems with this section
Gravel Stop
22 Gauge Cont Cleat, Strip-In Cover, 10' Lengths
Published sustained pressure: 24 gauge -140 psf (face to 10"); .040 AL -130 psf (face to 10")
Gravel Stop installation sequenceEcono Gravel Stop
24 Gauge Cont Cleat, Strip-In Cover, 10' Lengths
Published sustained pressure: 24 gauge -70 psf (face to 7"); .040 AL -90 psf (face to 7")
Econo Gravel Stop installation sequence- Ratings as Drexel Metals publishes them for its own tested assemblies, not for a drawing made here. Design Engineer must apply the Factor of Safety.