Detail Atlas · Drip Edge & Roof Edge
Drip Edge
The FlashDraft section for this condition, in 3D and as a lettered section.
Show
Loading 3D view…
Legs
| Leg | Length |
|---|---|
| A | 2" |
| B | 1" |
| C | Drawn to proportion - set it in FlashDraft |
| D | 1/2" |
Related calculators
- Flashing Profile & Bend Development - Legs, bends and hems to a blank width, bend schedule, weight and an AFS fabrication check.
- Roof Edge, Coping & Fascia - Edge runs, corners and terminations to pieces, joints, end caps and cleat length.
- Thermal Movement & Compatibility - Expansion and contraction of a run between metal temperature extremes, and dissimilar-metal screening.
- Wind Uplift & Edge Screening - ASCE 7-16 edge pressures for comparison with ES-1 tested capacity. Preliminary.
Drexel ES-1 systems with this section
Drip Edge LT
24 Gauge Cont Cleat, Strip-In Cover, 10' Lengths
Published sustained pressure: 24 gauge -240 psf (face to 6"); .040 AL -250 psf (face to 6")
Drip Edge LT installation sequenceDrip Edge
22 Gauge Cont Cleat, Strip-In Cover, 10' Lengths
Published sustained pressure: 24 gauge -175 psf (face to 6"); .040 AL -185 psf (face to 6")
Drip Edge installation sequence- Ratings as Drexel Metals publishes them for its own tested assemblies, not for a drawing made here. Design Engineer must apply the Factor of Safety.